|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
<< back to Environmental System Protection Home Page Hydrant Usage Steps/Procedures Bulk
Water Haulers PWC
has established formal guidelines/policy governing the use of Public Works
Commission owned fire hydrants (Fire Hydrant Policy). ONLY
PWC permitted vehicles are allowed to fill from fire hydrants. Persons
desiring to obtain water from fire hydrants shall be referred to as Bulk
Water Haulers (herein after referred to as BWH). BWH's shall be permitted
by PWC to discharge water from a designated fire hydrant into a tank with
an Approved Air Gap (AAG). Listed below are the steps/procedures required to set up an account with PWC in order to obtain water from a fire hydrant. Questions concerning the PWC Bulk Water procedures may be directed to the PWC Water Resources Environmental Department/Environmental System Protection Section. You may contact the PWC System Protection Staff at the following numbers: Brian Morrison at 223-4704 or Jeff Williams at 223-4754. Application
Steps 2.
Applicant shall contact the Public Works Commission's Environmental System
Protection Section at (910) 223-4704 in order to report the number of
tank loads of water obtained the prior week. Loads obtained shall be reported
every Monday morning. BWH's are required to display a fire hydrant permit sticker on the tank of their vehicle and must have the permit form within the vehicle at all times.
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Public
Works Commission |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||